Document Actions
Accessories
|
Sound indication is available only for 5000 series devices (Outdoor) with channel testing mode on (RMA command with Autotest option). The device is intended to be used while preliminary link establishing and antenna alignment procedure in order to obtain the maximum signal level from the remote side. When having AudioMonitor plugged into the console port of the device with headphones plugged in, the sound signals will be sent to the headphones. The AudioMonitor or the console cable must be plugged in when the device is powered off. |
|
No return packets state on the testing device input (no link) with described testing mode turned on is indicated by seldom tones in the headphones. If there is a link established, the signal level is indicated by the set of clicks. The higher the signal level, the higher is the frequency of the clicks and their number in the set. The durability of the set and the interval between the sets is always the same and has a value of 2 and 0.5 seconds correspondingly. The indication cycle always corresponds with a PREVIOUS measurement cycle. That means that the sound indication has a delay of 2.5 seconds. The maximum signal level (16) is indicated by a permanent tone. |
Console Cable
|
Console cable is used to connect the ODU unit (for Outdoor devices) and a PC to make preliminary configuration changes. The cable has a standard COM-port connector to be plugged into the PC and specialized DB9 connector to be plugged into ODU console port. |
Metal plate for R5000-S & R5000-M wall mounting
|
The plate is used for wall mounting of R5000-M and R5000-S units. It is not included into a standard packing list for the equipment (standard mounting kit includes a pole mounting kit) and should be ordered separately |
Rack Mount
|
Rack Mount has a size of 1U for mounting into a standard 19" rack. Can be used for: • Two IDU (indoor power supply unit) mounting • Two Indoor Routers mounting |
|
Connectors wrench
|
The wrench is a convenient tool for the service cable connectors tightening. As shown on the picture on the right, you can reach the connector using the wrench and screw/unscrew it easily |
|
|
|